Parameterisation Via Configuration Data; Parameterisation With The Operator Unit Cpx-Mmi; Parameterisation In The Plc User Program - Festo CPX-FB36 Electronics Description

3. Commissioning

3.2.3 Parameterisation via configuration data

3.2.4 Parameterisation with the operator unit CPX-MMI

3.2.5 Parameterisation in the PLC user program

3-26
Note
The last parameterisation transferred in the CPX terminal is
always valid.
Parameterisation via configuration data (Configuration As-
sembly) corresponds to the method for configuration with
CPX-FMT and transfer of all parameters to the "RSLogix" pro-
gram ( section 3.1.3).
The operator unit CPX-MMI offers menu-driven access to the
parameterisation. It does not require any additional configur-
ation software.
Information about using the operator unit can be found in the
corresponding description.
Program-controlled access to parameters is effected via "Ex-
plicit Messaging". The addresses of the EtherNet/IP object
model that are required for this can be found in Appendix C.1.
Further information on programming this data transmission
can be found in the manual for your controller.
Festo P.BE-CPX-FB36-EN en 1309NH English