Festo CPX-FB36 Electronics Description page 115

B. Address assignment of the CPX terminal
Electric modules
Designation
Bus node for EtherNet/IP
in Remote I/O operating mode
without diagnostic access
Bus node for EtherNet/IP
in Remote I/O operating mode
with status bits [Status]
Bus node for EtherNet/IP
in Remote I/O operating mode
with I/O diagnostic interface
[System Table Interface, STI]
Digital 4-off input module
Digital 8-off input module
Digital 8-off input module with
channel diagnostics
Digital 8-input module, n-switching:
Digital 16-off input module
Digital 16-off input module with
channel diagnostics
Digital 16-off input module with
terminal strip
1) Module identifier in the operator unit or in the hardware configuration of the programming
software
2) Number of occupied I/O bytes in the Remote Controller operating mode:
3) Diagnostics mode status bits assigned 2 bytes of address space (8 I or 8 bits remain unused);
4-off modules (CPX-4DE and CPX-4DA) occupy 8 I or 8 O, or 1 byte of address space (4 I/O or 4 bits
of address space remain unused)
Tab. B/1: Address assignment of electric CPX modules (overview; bus node in Remote
I/O operating mode) – Part 1
Festo P.BE-CPX-FB36-EN en 1309NH English
Module
type
CPX-FB36
2)
CPX-FB36
2)
CPX-FB36
2)
CPX-4DE
CPX-8DE
CPX-8DE-D
CPX-8NDE
CPX-16DE
CPX-
M-16DE-D
CPX-L-16DE-
16-KL-3POL
Module Allocated address
1)
identifier space
Inputs
FB36-RIO... –
FB36-RIO... 2 bytes/
8 (16) E
(8 bit used)
FB36-RIO... 2 bytes/16I
4DI 1 byte/4 (8)
3)
I
8DI 1 byte/8 I
8DI-D 1 byte/8 I
8NDI 1 byte/8 I
16DI 2 bytes/16 I
16DI-D 2 bytes/16 I
L-16DI-PI 2 bytes/16 I
Outputs
–
–
3)
2 bytes/
16 O
–
–
–
–
–
–
–
Tab. B/4
B-5