Festo CPX-FB36 Electronics Description page 26

1. Installation
1-8
Procedure
1. Switch off the power supply.
2. Remove the DIL switch cover.
3. Change the DIL switch settings (
4. Mount the cover.
Remove the DIL switch cover
1. Unscrew the two mounting screws in the switch cover.
2. Lift off the cover.
Mounting the DIL switch cover
1. Place the cover carefully on the bus node.
Note
Make sure that the seal is seated correctly.
•
2. Tighten the two mounting screws at first by hand and
then with a max. tightening torque of 0.4 Nm.
section1.2.1 ff.).
Festo P.BE-CPX-FB36-EN en 1309NH English