Festo CPX-FB36 Electronics Description page 81

3. Commissioning
1
"Assembly-
lnstance" connec-
tion parameter
for "Configura-
tion"
Festo P.BE-CPX-FB36-EN en 1309NH English
To change the "Configuration" connection parameter using
the "RSLogix" programme, proceed as follows:
1. Make sure there is no online connection between RSLogix
and the controller (
2. Double-click the "Ethernet" branch in the "Controller Or-
ganizer" window to open the "Module Properties" dia-
logue window.
Fig. 3/11: "Module Properties" dialogue window
3. Enter the value "0" for "Configuration" under the As-
sembly Instance "Connection Parameters" field.
4. Close the "Module Properties" dialogue window by press-
ing "Finish >>".
The setting "System start with saved parameters" is indicated
by the permanent illumination of the M-LED on the bus node
after the system has started.
"Communications"
1
"Go offline").
3-23