Table of Contents
Advertisement
Issue 6
8 - 48
14.4.4
Installing the Driver on the PC
Using the setup disk provided with the CT(A)-R Unit
install the driver onto your PC. Refer to the CT(A)
installation Guide for instructions on installing CT(A)
setup disks.
14.5
Removing or Installing BS(E)-R Key Unit
This unit can be removed as follows:
1.
Remove the Line Card and Line Panel from the Multiline
Terminal.
2.
Pull the tab on the right side of the key unit and lift out the unit
to the left as shown in
Install this unit as follows:
1.
Insert the two tabs on the left of the key unit in the slots as
shown in
Installing Electra Elite IPK and D
Figure 8-62 Removing Key
Figure 8-62 Removing Key Unit
Figure 8-63 Installing Key
Electra Elite
Unit.
Unit.
term
Series i Equipment
Advertisement
Table of Contents
