Connecting Dcu Attendant Console To A Multiline Terminal; Figure 6-13 Connecting The Line Cord And Ac Adapter When Installing A Dcu Attendant Console - NEC ElectraElite 48 System Hardware Manual

Issue 6
S 5
ECTION
C DCU
ONNECTING
A C
TTENDANT ONSOLE
M
TO A ULTILINE
T
ERMINAL
6 - 12
An Attendant Console can be attached to a Multiline Terminal using the
following procedures.
1. Turn the Multiline Terminal and the Attendant Console face down.
2. Using the joining plate provided with the Attendant Console, attach
the plate to the Multiline Terminal and the Attendant Console.
3. Connect the line cord and the AC adapter to the indicated locations
on the bottom of the Attendant Console.
Figure 6-13 Connecting the Line Cord and AC Adapter when Installing a
DCU Attendant Console
4. When the Attendant Console and the Multiline Terminal are properly
connected, they sit side-by-side as shown in
Attendant Console and Multiline
Ensure that the AC adapter, supplied with the Attendant Console, is
used. Using a different AC adapter may cause problems. Check that
the supplied voltage matches that of the adapter and plug it in an
outlet.
Line Cord Jack
AC Adapter Plug
Figure 6-14 DCU
Terminal.
Installing Electra Elite Multiline Terminals
Electra Elite