Removing The Air Baffle - IBM Storwize V7000 Unified Problem Determination Manual

8. Start the Setup utility and reset the configuration.

Removing the air baffle

The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
About this task
When you work with some replaceable devices, you must first remove the DIMM
air baffle to access certain components or connectors on the system board.
To remove the DIMM air baffle, complete the following steps.
Air baffle
Figure 59. Removing the air baffle
Procedure
1. Read the safety information that begins on page Safety and "Installation
Note: You must wait approximately 2.5 minutes after you connect the power
cord of the file module to an electrical outlet before the power-control button
becomes active.
v Set the system date and time.
v Set the power-on password.
v Reconfigure the file module.
guidelines" on page 94.
PCI riser-card
assembly 1
Chapter 4. File module
137