Installing The Battery - IBM Storwize V7000 Unified Problem Determination Manual

For more information, see the IBM Environmental Notices and User's Guide on the
IBM Documentation CD.
To install the replacement battery, complete the following steps:
Procedure
1. Follow any special handling and installation instructions that come with the
2. Insert the new battery:
Battery
Figure 58. Installing the battery
3. Reinstall any adapters that you removed.
4. Reconnect the internal cables that you disconnected.
5. Install the cover, as described in Installing the cover.
6. Slide the file module into the rack.
7.
136
Storwize V7000 Unified: Problem Determination Guide 2073-720
replacement battery.
a. Tilt the battery so that you can insert it into the socket on the side opposite
the battery clip.
b. Press the battery down into the socket until it clicks into place. Make sure
that the battery clip holds the battery securely.
c. If you removed a rubber cover from the battery holder, use your fingers to
install the battery cover on top of the battery connector.
Follow the steps at the end of the procedure in "Removing a file module and
disconnecting power" on page 92 to suspend the file module to reconnect the
file module and resume its use in the cluster.