Sas Ports On The Node Canisters; Gbps Ethernet Port Leds; Sas Port Leds On The Node Canister - IBM Storwize V7000 Unified Problem Determination Manual

Node canister SAS ports and indicators
Two serial-attached SCSI (SAS) ports are located side by side in the rear of the
node canister.
The SAS ports are numbered 1 on the left and 2 on the right as shown in Figure 33.
Port 1 is used if you add one expansion enclosure. Port 2 is used if you add a
second expansion enclosure. Each port provides four data channels.
Note: The reference to the left and right locations applies to canister 1, which is
the upper canister. The port locations are inverted for canister 2, which is the lower
canister.
Figure 33. SAS ports on the node canisters.
SAS ports must be connected to Storwize V7000 Unified enclosures only. See
"Problem: Storwize V7000 Gen1 SAS cabling not valid" on page 248 for help in
attaching the SAS cables.
Four LEDs are located with each port. Each LED describes the status of one data
channel within the port. The data channel number is shown with the LED.
Table 22. 10 Gbps Ethernet port LEDs
Name Symbol
Activity Tx/Rx
Link LNK
Table 23. SAS port LEDs on the node canister
LED state
Off
Flashing
On
Description
The LED is flashing when there is
activity on the link; otherwise, the
LED is off.
The LED is on when there is a
link connection; otherwise, the
LED is off.
Description
No link is connected.
The link is connected and has activity.
The link is connected.
Chapter 1. Storwize V7000 Unified hardware components
Color
Green
Amber
29