IBM Storwize V7000 Unified Problem Determination Manual page 175

Table of Contents

Advertisement

Retention
brackets
5. Grasp the network adapter and disengage it from the pin, standoffs, retention
brackets, and the connector on the system board; then, lift the adapter out of
the port openings on the rear of the chassis and remove it from the server.
6. If you are instructed to return the network adapter, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Installing a 10-Gbps Ethernet adapter
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
About this task
The file module has a Emulex dual port 10GbE SFP+ Embedded VFA III adapter.
To install the network adapter, complete the following steps:
Procedure
1. Read the Safety information and "Installation guidelines" on page 94.
2.
Follow the procedure in "Removing a file module and disconnecting power"
on page 92 to suspend the file module from the cluster and shut it down, and
then disconnect all power cords and external cables.
3. Remove the cover (see "Removing the cover" on page 123).
4. Touch the static-protective package that contains the new adapter to any
unpainted metal surface on the file module, and then remove the adapter
from the package.
5. Align the adapter so that the port connectors on the adapter line up with the
pin and thumbscrew on the chassis; then, align the connector of the adapter
with the adapter connector on the system board.
Network
adapter
Captive screws
Network
adapter connector
Screw holes
Thumbscrew
Pin
Chapter 4. File module
147

Advertisement

Table of Contents
loading

Table of Contents