Installing A Pci Riser-Card Assembly - IBM Storwize V7000 Unified Problem Determination Manual

Figure 63. Installing a PCI riser-card assembly
Procedure
1. Reinstall any adapters.
2. Align the PCI riser-card assembly with the selected PCI connector on the
3. Press down on the assembly. Make sure that the riser-card assembly is fully
4. Install the file module cover. For more information, see Installing the cover.
5. Slide the file module into the rack.
6.
Removing a PCI adapter from a PCI riser-card assembly
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
system board:
Note: The chassis might sag after you remove the riser assembly. In this case,
lift the bottom of the chassis to line up the slots on the side of the assembly to
the alignment brackets in the side of the chassis.
v PCI connector 1: Carefully fit the two alignment slots on the side of the
assembly onto the two alignment brackets in the side of the chassis.
seated in the riser-card connector on the system board.
Follow the steps at the end of the procedure in "Removing a file module and
disconnecting power" on page 92 to suspend the file module to reconnect the
file module and resume its use in the cluster.
PCI riser-card
assembly
Chapter 4. File module
143