IBM Storwize V7000 Unified Problem Determination Manual page 241

Create system command:
Use this command to create a storage system.
Note: The reference to cluster is not the same as the file system cluster on the
Storwize V7000 file modules.
Attention: Run this command only when instructed by IBM support. Running
this command directly on a Storwize V7000 can affect your I/O operations on the
file modules.
Syntax
►► satask mkcluster -clusterip
►► satask mkcluster -clusterip_6
Parameters
-clusterip ipv4
(Optional) The IPv4 address for Ethernet port 1 on the system.
-gw ipv4
(Optional) The IPv4 gateway for Ethernet port 1 on the system.
-mask ipv4
(Optional) The IPv4 subnet for Ethernet port 1 on the system.
-clusterip_6 ipv6
(Optional) The IPv6 address for Ethernet port 1 on the system.
-gw_6 ipv6
(Optional) The IPv6 gateway for Ethernet port 1 on the system.
-prefix_6 int
(Optional) The IPv6 prefix for Ethernet port 1 on the system.
-name cluster_name
(Optional) The name of the new system.
Description
This command creates a storage system.
This command calls the satask mkcluster command.
Change system IP address:
Use this command to change the system IP address of the storage system.
It is best to use the initialization tool to create this command in satask.txt together
with the associated clitask.txt file that changes the file modules management IP
addresses.
ipv4
-gw ipv4 -mask ipv4
ipv6
-gw_6 ipv6 -prefix_6
-name cluster_name
int -name cluster_name
Chapter 5. Control enclosure
►◄
►◄
213