IBM Storwize V7000 Unified Problem Determination Manual page 186

Procedure
1. Rotate the air baffle up.
2. Orient the new dual-motor hot-swap fan over its position in the dual-motor
3. Align the vertical tabs on the dual-motor hot-swap fan with the slots on the
4. Push the new dual-motor hot-swap fan into the dual-motor hot-swap fan
5. Repeat steps 1 through 3 until all the new or replacement dual-motor hot-swap
6. Install the cover (see "Installing the cover" on page 124).
7. Slide the file module into the rack.
Removing a hot-swap ac power supply
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
About this task
To remove a power supply, complete the following steps:
158
Storwize V7000 Unified: Problem Determination Guide 2073-720
Fan 3
Fan 2
hot-swap fan bracket so that the connector on the bottom aligns with the
dual-motor hot-swap fan connector on the system board.
dual-motor hot-swap fan cage bracket.
connector on the system board. Press down on the top surface of the
dual-motor hot-swap fan to seat the dual-motor hot-swap fan fully. (Make sure
that the LED has turned off.)
fans are installed.
Vertical tabs
Fan 1