Compressing Rail For Removal From Rack - IBM Storwize V7000 Unified Problem Determination Manual

Figure 112. Compressing rail for removal from rack
12. Repeat steps 9 on page 363 to 11 on page 364 on the right support rail.
13. Install the new support rails at the rack position that is recorded at step 8 on
14. Reinstall the enclosure (removed at step 7 on page 363) and the end caps
15. If components were removed from the enclosure at step 7 on page 363, return
16. Reconnect the cables, ensuring that they are connected to their original ports.
17. Reconnect the power supply cables to their original power supply and
18. After the system is online, use the management GUI to verify that the system
Replacing the Storwize V7000 Gen2 expansion enclosure
support rails
You can replace faulty support rails with new ones received from CRU / FRU
stock.
page 363 by following the instructions in Step 6. Installing the support rails
for the enclosures.
(removed at step 5 on page 363) by following the instructions in Step 7.
Installing the enclosures.
each canister, drive assembly, and power supply unit to its labeled slot.
electrical outlet.
The system starts.
is correct.
Chapter 5. Control enclosure
365