IBM Storwize V7000 Unified Problem Determination Manual page 109

Table 43. LED indicators, corresponding problem causes, and corrective actions (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v If an action step is preceded by "(Trained technician only)," that step must be completed only by a trained
technician.
LED Problem
PCI An error occurred on a PCI card,
a PCI bus, or on the system
board. An extra LED is lit next to
a failing PCI slot.
NMI An interrupt that cannot be
masked occurred, or the NMI
button was pressed.
Action
1. If the CONFIG LED is not lit, complete the following
steps to correct the problem:
a. Check the riser-card LEDs, the ServeRAID error LED,
and the optional network adapter error LED to
identify the component that caused the error.
b. Check the system-error log for information about the
error.
c. If you cannot isolate the failing component by using
the LEDs and the information in the system-error log,
remove one component at a time; and restart the file
module after each component is removed.
d. Replace the following components, in the order that is
shown, restarting the file module each time:
v PCI riser cards
v ServeRAID adapter
v Optional network adapter
v (Trained technician only) System board
e. If the failure remains, go to http://www.ibm.com/
systems/support/supportsite.wss/
docdisplay?brandind=5000008&lndocid=SERV-CALL.
2. If the PCI LED and the CONFIG LED are lit, complete the
following steps to correct the problem:
a. Check the microprocessor that is installed is Intel
E5-2690.
b. Remove the high-power (>25 Watt) adapter.
c. Check the system-error logs for information about the
error. Replace any component that is identified in the
error log.
1. Check the system-error log for information about the
error.
2. Restart the file module.
Chapter 3. Getting started troubleshooting
81