Installing The Bezel - IBM Storwize V7000 Unified Problem Determination Manual

Figure 53. Installing the bezel
Procedure
1. Insert the tabs on the bottom of the bezel into the slots on the underside of the
2. Connect any cables that you previously removed from the front of the file
Removing the 240 VA safety cover
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
To remove the 240 VA safety cover, complete the following steps:
1. Read the Safety information and "Installation guidelines" on page 94.
2.
3. Pull the file module out of the rack.
4. Remove the file module cover (see "Removing the cover" on page 123).
chassis and attach it with the screws.
module.
Follow the procedure in "Removing a file module and disconnecting power"
on page 92 to suspend the file module from the cluster and shut it down, and
then disconnect all power cords and external cables.
127
Chapter 4. File module