Compressing Rail For Removal From Rack - IBM Storwize V7000 Unified Problem Determination Manual

Figure 114. Compressing rail for removal from rack
12. Repeat steps 9 on page 366 to Figure 114 on the right support rail.
13. Install the new support rails at the rack position that is recorded at step 8 on
14. Reinstall the enclosure (removed at step 7 on page 366) and the end caps
15. If components were removed from the enclosure at step 7 on page 366, return
16. Reconnect the cables, ensuring that they are connected to their original ports.
17. Reconnect the power supply cables to their original power supply and
18. After the system is online, use the management GUI to verify that the system
Replacing the Storwize V7000 Gen1 support rails
You can replace the support rails.
368
Storwize V7000 Unified: Problem Determination Guide 2073-720
page 366 by following the instructions in Step 6. Installing the support rails
for the enclosures.
(removed at step 5 on page 366) by following the instructions in Step 7.
Installing the enclosures.
each canister, drive assembly, and power supply unit to its labeled slot.
electrical outlet.
The system starts.
is correct.