When To Use The Management Gui - IBM Storwize V7000 Unified Problem Determination Manual

Unfixed messages and alerts
Show all
Some events require a certain number of occurrences in 25 hours before they are
displayed as unfixed. If they do not reach this threshold in 25 hours, they are
flagged as expired. Monitoring events are below the coalesce threshold and are
usually transient.
You can also sort events by time or error code. When you sort by error code, the
most serious events, those with the lowest numbers, are displayed first. You can
select any event that is listed and select Actions > Properties to view details about
the event.
v Recommended Actions. For each problem that is selected, you can:
v Event log. For each entry that is selected, you can:

When to use the management GUI

The management GUI is the primary tool that is used to service your system.
Regularly monitor the status of the system using the management GUI. If you
suspect a problem, use the management GUI first to diagnose and resolve the
problem.
Use the views that are available in the management GUI to verify the status of the
system, the hardware devices, the physical storage, and the available volumes. The
88
Storwize V7000 Unified: Problem Determination Guide 2073-720
v Run a fix procedure.
v View the properties.
Displays only the alerts and messages that are not fixed. For each entry
that is selected, you can:
v Run a fix procedure on any alert with an error code.
v Mark an event as fixed.
v Filter the entries to show them by specific minutes, hours, or dates.
v Reset the date filter.
v View the properties.
Displays all event types whether they are fixed or unfixed. For each entry
that is selected, you can:
v Run a fix procedure on any alert with an error code.
v Mark an event as fixed.
v Filter the entries to show them by specific minutes, hours, or dates.
v Reset the date filter.
v View the properties.
– Run a fix procedure.
– View the properties.
– Run a fix procedure.
– Mark an event as fixed.
– Filter the entries to show them by specific minutes, hours, or dates.
– Reset the date filter.
– View the properties.