IBM Storwize V7000 Unified Problem Determination Manual page 184

Table of Contents

Advertisement

10. Follow the steps at the end of the procedure "Removing a file module and
11. Go to the management GUI and look for any unfixed events related to
Removing a hot-swap fan
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
About this task
Attention:
dual-motor hot-swap fan with the system running, you must install a replacement
dual-motor hot-swap fan within 30 seconds or the system will shut down.
To remove any of the three replaceable dual-motor hot-swap fans, complete the
following steps.
Procedure
1. Read the Safety information and "Installation guidelines" on page 94.
2. Leave the file module connected to power.
156
Storwize V7000 Unified: Problem Determination Guide 2073-720
disconnecting power" on page 92 to reconnect the file module and resume its
use in the cluster.
DIMMs.
To ensure proper file module operation and cooling, if you remove a
Fan 3
Fan 2
Vertical tabs
Fan 1

Advertisement

Table of Contents
loading

Table of Contents