IBM Storwize V7000 Unified Problem Determination Manual page 191

About this task
To remove the operator information panel assembly, complete the following steps.
Operator information
panel
Procedure
1. Read the Safety information and "Installation guidelines" on page 94.
2. Follow the procedure in "Removing a file module and disconnecting power" on
page 92 to suspend the file module from the cluster and shut it down, and then
disconnect all power cords and external cables.
3. Remove the cover (see "Removing the cover" on page 123).
4. Disconnect the cable from the back of the operator information panel assembly.
5. Reach inside the file module and press the release tab; then, while you hold the
release tab down, push the assembly toward the front of the file module.
6. From the front of the file module, carefully pull the operator information panel
assembly out of the file module.
7. If you are instructed to return the operator information panel assembly, follow
all packaging instructions, and use any packaging materials for shipping that
are supplied to you.
Installing the operator information panel assembly
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
About this task
To install the replacement operator information panel assembly, complete the
following steps.
163
Chapter 4. File module