IBM Storwize V7000 Unified Problem Determination Manual page 453

Table 120. Upgrade error codes and recommended actions (continued)
Error
Code Explanation
01E7 Unable to ping node
01E8 Unable to apply firmware to
Emulex adapters.
01FF NAS upgrade cannot continue
because a system upgrade is in
progress.
0200 A failure has occurred while
reading the registry.
0201 Unable to open CIM configuration
file.
0202 Unable to update CIM
configuration.
0511 Unable to disable CNSCM
monitoring.
0513 Management service could not be
stopped
0514 Database backup failed
0515 Database backup failed
Action
1. Verify that the node is powered on. If
yes, ping the node.
2. Restart the node and then, ping the
node.
3. Check the network connections and
correct them, if required.
4. Contact IBM Remote Technical
Support.
Contact IBM Remote Technical Support.
Enter svcinfo lsupdate to check the state
of the system upgrade.
v If the status is system_updating or
system_completing, allow the upgrade
to complete. Then restart the NAS
upgrade from the file modules.
v If the status is system_prepared, stop
the current upgrade by entering
svctask applysoftware -abort. Then
restart the NAS upgrade from the file
modules.
If lsupdate is not available enter svcinfo
lsupdate to check the state of the system
upgrade.
v If the status is upgrading, allow the
upgrade to complete. Then restart the
NAS upgrade from the file modules.
v If the status is prepared, stop the
current upgrade by entering svctask
applysoftware -abort. Then restart the
NAS upgrade from the file modules.
1. Use lsnode to check the status of
CTDB and GPFS for the nodes.
Reboot the unhealthy node and wait
for the node to be up again. Then,
again check the health of the node
with lsnode.
2. Contact IBM Remote Technical
Support.
Contact IBM Remote Technical Support.
Contact IBM Remote Technical Support.
Contact IBM Remote Technical Support.
Contact IBM Remote Technical Support.
Contact IBM Remote Technical Support.
Contact IBM Remote Technical Support.
Chapter 7. Recovery procedures
425