GE MM3 Instruction Manual page 88

5.6 A4 STATISTICS
PATH: ACTUAL VALUES
INTERLOCK COUNTER =
34765 UNITS
MESSAGE
NUMBER OF STARTS =
MESSAGE
26
TOTAL TRIPS =
MESSAGE
6
OVERLOAD TRIPS =
MESSAGE
1
THERMISTOR TRIPS =
MESSAGE
2
GROUND FAULT TRIPS =
MESSAGE
0
SINGLE PHASE TRIPS =
MESSAGE
0
ACCELERATION TRIPS =
5
MESSAGE
0
UNDERCURRENT TRIPS =
MESSAGE
0
UNDERPOWER TRIPS:
MESSAGE
0
STALLED ROTOR TRIPS:
MESSAGE
0
CONTROL COMMAND
MESSAGE
TRIPS: 3
5-12
MMMM MM
A4 STATISTICS
This is the total number of switch closures read by the MM3 on a
programmable input that has been configured to INTERLOCK COUNTER.
This is the total number of contactor operations. When the MM3 receives
feedback into either contactor status input to confirm that one of the main
contactors have closed, this counter will increment.
When the MM3 trips for any reason, this value is incremented. It is the
sum of all of the individual causes of trip.
When an overload trip occurs, this value is incremented.
When a thermistor trip occurs, this value is incremented.
When a ground fault trip occurs, this value is incremented.
When a single phase trip occurs, this value is incremented.
When a single phase trip occurs, this value is incremented.
When an undercurrent trip occurs, this value is incremented.
When an underpower trip occurs, this value is incremented.
If a stalled rotor trip occurs, this value is incremented.
If a control trip occurs, this value is incremented (i.e. Plant Interlock,
Local Isolator etc.)
MM3 Motor Manager 3
COUNTERS
5 ACTUAL VALUES
5.6.3 COUNTERS
GE Power Management