GE MM3 Instruction Manual page 83

5 ACTUAL VALUES
MOTOR GREASING
MESSAGE
INTERVAL EXCEEDED
CONTACT INSPECTION
MESSAGE
INTERVAL EXCEEDED
MAXIMUM MOTOR
MESSAGE
STOP TIME EXCEEDED
ANALOG HIGH
MESSAGE
ALARM
ANALOG LOW
MESSAGE
ALARM
PROCESS INTERLOCK A
MESSAGE
ALARM
PROCESS INTERLOCK B
MESSAGE
ALARM
PROCESS INTERLOCK C
MESSAGE
ALARM
PROCESS INTERLOCK D
MESSAGE
ALARM
PROCESS INTERLOCK E
MESSAGE
ALARM
PROCESS INTERLOCK F
MESSAGE
ALARM
PROCESS INTERLOCK G
MESSAGE
ALARM
PROCESS INTERLOCK H
MESSAGE
ALARM
PROCESS INTERLOCK I
MESSAGE
ALARM
PROCESS INTERLOCK J
MESSAGE
ALARM
MOTOR A TRIP ALARM =
MESSAGE
OVERLOAD
THERMAL CAPACITY
MESSAGE
ALARM
UNDERVOLTAGE
MESSAGE
ALARM
OVERVOLTAGE
MESSAGE
ALARM
START BLOCK
MESSAGE
ALARM
GE Power Management
The Motor Greasing Interval time has been exceeded.
The number of contactor operations has exceeded the Contactor
Inspection Interval Alarm count.
The time that the motor has remained stopped has exceeded the
Maximum Motor Stopped Time alarm level. This can be cleared by
starting the motor.
The Analog Input value has exceeded the Analog Input High Alarm Level
for the Analog Input High Alarm Time Delay.
The Analog Input value has dropped below the Analog Input Low Alarm
Level for the Analog Input Low Alarm Time Delay.
An open Process Interlock A switch input has been detected.
An open Process Interlock B switch input has been detected.
An open Process Interlock C switch input has been detected.
An open Process Interlock D switch input has been detected.
An open Process Interlock E switch input has been detected.
An open Process Interlock F switch input has been detected.
An open Process Interlock G switch input has been detected.
An open Process Interlock H switch input has been detected.
An open Process Interlock I switch input has been detected.
An open Process Interlock J switch input has been detected.
A Duty/Standby starter type motor has tripped. The cause of the trip is
displayed on the bottom line.
The thermal capacity used has exceeded the Alarm level.
The primary voltage measurement has dropped below the Alarm level.
The primary voltage measurement has exceeded the Alarm level.
A Start Block is in effect.
MM3 Motor Manager 3
5.4 A2 STATUS
5
5-7