Status Code Entry Chart - Xerox 3001 Service Manual

Status
Code
A 1
A3
A4
A5
A6
A7
A8
A9
Cause Clearance Procedure
While the fuser was warming up, a Remove the document from the copier.
document was i n the copier. Ensure that the
document handler is correctly seated.
A document was expected at the front Remove the media from the copier.
original sensor but the original had been
removed.
A document was expected at the rear Remove the media from the copier.
original sensor but the original was
removed.
The document did not reach the rear original Remove the document and the media from the copier.
sensor i n the correct amount of time.
While the fuser was warming up, a Remove the document from the copier
document was at the front document sensor.
Ensure that the document handler is
correctly seated.
A document was either less than 12 inches Remove the document from the copier.
(305mm) or more than 54 inches (1372mm)
long and the copier was
in
the multiple
copies mode.
While the copier was in the multiple copies Remove the second document from the copier.
mode, a document was at the rear of the
copier and another document was inserted
into the copier.
The document did not reach the front Remove the document and the media from the copier.
document sensor in the correct amount of
time.
Go to RAP in Section 2
A1 Document Handler RAP
A3 Document Handler RAP
A4 Document Handler RAP
A5 Document Handler RAP
A6 Document Handler RAP
A7 Document Handler RAP
A9 Document Handler RAP
12/98
Status Code Entry Chart
1-4 3001