Xerox 3001 Service Manual page 311

The 3001 is shipped with the
@
Photoreceptor Drum packed
Q
There is a packing spring inside the
Fuser Roll to support the Fuser Heat
separately. The Photoreceptor Drum
will be installed later in the
installa tion.
12.
REMOVE THE PHOTORECEPTOR DRUM
SHAFT ASSEMBLY (REP9.2).
13.
A
REMOVE
Rod during shipping. This packing
spring must be removed before
operating the 300 1.
(FIGURE 9): PREPARE TO REMOVE THE
PACKING SPRING.
F
REMOVE THE FUSER
ROLL BEARING
TRANSITION
REMOVE
DISCONNECT
SCREWS(2) (2
REMOVE THE
TIE WRAP
WIRE FROM CLIP
Figure 9. Prepare to Remove the Packing Spring
3001 Installation