Xerox 3001 Service Manual page 233

(Continued)
5.
(FIGURE 2): REMOVE THE WICK.
Figure 2. Remove the Wick
REPLACEMENT
Use care not to stretch the rubber
retainer while installing it. After -
1. (FIGURE 3): INSTALL THE WICK EDGE WlTH
installing the rubber retainer, ensure
THE NARROW PLASTIC STRIP.
that the rubber retainer is approximately
the same length as the wick. Cut any
excess off.
INSTALL WICK EDGE
WlTH THE NARROW
PLASTIC STRIP UP
ASTlC STRIP UP
INSTALLTHE RUBBER
RETAINER
Figure 3. Install the Wick Edge with the Narrow Plastic Strip
(Continued)
12/98
3001
4-53
REP 10.12