Rep 9.8 Developer Material - Xerox 3001 Service Manual

REP 9.8
DEVELOPER MATERIAL
PARTS LIST (REFER TO THE GENERAL TOOLS
AND SUPPLIES, CONSUMABLES
IN SECTION 6.)
R E M O V A L
W A R N I N G
DISCONNECT POWER CORD.
1. PLACE A LARGE SHEET OF PAPER ON THE
FLOOR.
2.
REMOVE THE DRY INK CARTRIDGE.
3. REMOVE THE DEVELOPER MODULE ( REP
9.5).
4. (FIGURE 1): REMOVE THE PICKOFF
BAFFLE.
5.
(FIGURE 2): DUMP THE DEVELOPER
3.
MATERIAL.
6. USING A VACUUM, ENSURE THAT THE 4.
DEVELOPER HOUSING IS CLEAN.
REPLACEMENT 5.
NOTE: Ensure that the developer drive idler
gear (PL l.la, item 13 is located against the
6.
frame or the drive will not occur.
a.
1.
INSTALL THE DEVELOPER MODULE ( REP
9.5).
b.
2. INSTALL THE DEVELOPER BY POURING
EVENLY END-TO-END AS THE MAIN
C.
MOTOR IS TURNED, BY HAND, IN THE
DIRECTION INDICATED BY THE ARROW
ON THE FAN.
RECORD THE DEVELOPER MATERIAL
BATCH NUMBER ON THE MACHINE LOG.
REINSTALL THE DRY INK/ TONER
CARTRIDGE.
ADJUST THE TONER DISPENSE SOLENOID
(ADJ 9.3).
PERFORM:
AUTOMATIC DETONING PROCEDURE
(SECTION 6).
ELECTROSTATIC SERIES (ADJ 9.2)
IMAGE DENSITY (ADJ 9.4)
PICK OFF BAFFLE
I
I
Figure
1.
Remove the Pick
I
PLACE
DROP CLOTH
ON FLOOR
ROTATE GEAR
COUNTERCLOCKWISE
Dff Baffle Figure 2. Dump the Developer Material
YBF SD5 M
E F t
REP 9.8