Rep 8.5 Fabric Guide - Xerox 3001 Service Manual

REP 8.5 FABRIC GUIDE
PARTS LIST ON PL 8.2
REMOVAL
1.
WARNING: DISCONNECT THE POWER
CORD.
NOTE: The media transport is shown
REPWCEMENT
removed for clarity. The transport
does not have to be removed to
STEP 1 A (US0 ONLY): The coloredstrip
replace the faabric guide.
on the fabric guide is closer to the edge
with the corner cut. This must be
5. (FIGURE 1): REMOVE THE FABRIC GUIDE.
positioned toward the back of the copier
REMOVE THE
RETAINING ROD
FABRIC GUIDE
OUT OF THE SLOT SLOT
L - - '
Figure 1. Remove the Fabric Guide
to avoid damage to the fabric guide and
possible media jams. Install the retaining
rod on this side.
1. (FIGURE 2): INSTALL THE RETAINING ROD
AND THE WEIGHT BAR INTO THE FABRIC
GUIDE.
2. THE REMAINDER OF THE REPLACEMENT IS
THE REVERSE OF THE REMOVAL
PROCEDURE.
INSTALL THE
RETAINING ROD
INSTALL THE
CORNER CUT
COLORED STRIP (US0 ONLY)
Figure 2. Install the Retaining Rod and the Weight
Bar into the Fabric Guide
REP 8.5