Status Code Entry Chart - Xerox 2510 Service Manual

STATUS
CODE
A
b
1
Flashing
b
C
J
Low Toner
Light not Lit
1
Low Toner
Light Lit
U
Constant P
Constant
L9
or
L 8
CAUSE
CLEARANCE PROCEDURE GO TO RAP IN
SECTION 2
A document was inserted before the Remove document, press Start and wait for Ready to
A
-
Document Sensor RAP
copy paper was registered. come on and reinsert copy paper and document.
Control PWB Failure
The transport latching cover is open or
the
upper
roor
cover
i s
off.
Paper Path Jam.
Fuser Failure
Foreign accessory prevents printing or
has a malfunction
Excessive toner concentration
Insufficient toner concentration
Copy Count Meter is disconnected.
Copier i s in i t s warm up cycle.
Copier
is
in the power saver mode.
Copier does not warm up.
Switch off the copier, then switch on the copier.
Record the NVM values.
Replace the control pwb.
1
(2515 only) Enter the NVM values recorded previously.
Reset
NVM.
Select the lower right hand segment.
Close the transport latching cover. Check that the
upper
rear cover Is In
place.
Clear the paper jam. Open, then close the transport
latching cover
Switch off the copier, then switch on the copier.
Insert required coin or cord,
Replace dry
ink
cartridge, Run copier for three time-
out cycles.
Reconnect counter,
Wait for Fuser to warm up. Display should be
counting down from L9 to LO.
Press the Start button.
Switch off the copier, then switch on the copier.
C
-
Cover Interlock Open RAP
E
-
Paper Path Jam RAP
F
-
Fuser RAP
W
-
foreign accessory Hap 3.2
or 3.3
J
-
High Torler Concentration
RAP 1
J
-
Low Toner Concentration
RAP 2
U
-
Copy Count Meter RAP
F
-
Fuser RAP
Status Code Entry Chart