Damaged Media Rap - Xerox 3001 Service Manual

Damaged Media RAP Probable Cause Corrective Action
1. Crease Marks 1. This defect can be caused by handling the 1. Ensure that the media is stored correctly
A thin irregular line on the media
media incorrectly. and is not folded or creased when inserted
because of stressing the media.
i n the copier.
2. Damaged Supply Roll 2. Rolled media was not handled correctly and 2. Replace the media roll.
could have fallen on a hard surface during
There could be a flattened area at one
handling of the roll.
end of the roll.
3. DOGEARS 3. Curled or roll cut media. 3. Use the cut sheet media.
This is a corner of the lead edge of the Detackcorotron
copy that has been bent back.
Check for obstruction caused by the detack
corotron.
4. Frayed Side Edge 4. Damaged media supply roll. 4. Replace the media roll.
This is damage t o the sides of the copy.
Incorrect media side t o side registration. Ensure that the media is inserted between
Obstruction in the media path.
the guide marks on the media feed-in shelf.
Check the media path for an obstruction.
5. Oil Streaks
Streaks on the copy.
5. Contamination or excessive amount of oil 5. Clean or replace the Oil Pad (REP 10.4) and
on the fuser oil pad and wick. wick (REP 10.5
).
Adjust Oil Dispenser (ADJ 10.2).
(Continued)
Damaged Media RAP