Adj 5.1 Copy Size Adjustment - Xerox 3001 Service Manual

ADJ 5.1 COPY SIZE ADJUSTMENT
Purpose
The purpose of this adjustment is t o obtain a
size for size copy using the customer's media.
This adjustment compensates for the media
stretching or shrinking t o make the image the
same size as the original.
Check
2. PLACE THE COPY ON TOP OF THE TEST
PATTERN.
3. (FIGURE 1): CHECK THE VERTICAL
MAGNIFICATION SCALE REFERENCE
MARKS ON THE TEST PATTERN TO THE
MARKS ON THE COPY.
Adjust
4. ENTER THE DIAGNOSTIC MODE.
Q
Increasing the value displayed on the
control panel will increase the length of
the image on the copy. Decreasing the
value displayed will shorten the image
on the copy.
7. USE
THEA
BUTTON IN ORDER TO
INCREASE OR THE
\/
BUTTON IN ORDER
TO DECREASE THE VALUE DISPLAYED ON
THE CONTROL PANEL.
Q
The test pattern 82E 5980 must be fed
5. SET THE SPECIAL TEST CODES [21], [22]
lead edge first in the
36
inch (914 mm)
AND [23] TO ZERO.
direction. Keep the copy media within
A. SELECT THE CODE.
the
36
inch (914 mm) marks on the feed-
B. PRESS Start.
in shelf. C. SET THE VALUE DISPLAYED TO 0.
1. MAKE A COPY OF 82E5980 ON THE
D. PRESS Start.
CUSTOMER'S
20 POUND (USO) 80 GSM (RX) 6. THE ARROW ENTER
BOND PAPER.
CODE [24]. PRESS THE Start BUTTON.
ALIGN 0 REFERENCE MARKS
COeY TEST PATTERN
ONE HALF OF THE UNlT LINES
EEEEEEEEEE33331
\
3333333333EEEEE
3333333333EEEEE
Vertical
3333333333EEEEE
Mag. Scale
h
,
mFnmfel
B'
a
#I.
=
i~ allh
COPY REGISTRATION
MARKS MUST BE
h
-
rnFnmfel WITHIN ONE HALF OF
a 1
1 1 1
n iE
ellh
THE UNlT LINES OF
I
1
1317
I L
THE TEST PATTERN
1 -
Check Reference Marks on the Test Pattern to Marks on the Copy
8. PRESS THE Start BUTTON TO STORE THE
NEW SETTING.
Q
When making a copy t o check the
adjustment, ensure that the correct
Copy Media button is pressed. This will
ensure the correct document speed is
selected.
9. EXIT THE DIAGNOSTIC MODE AND MAKE A
COPY OF THE TEST PATTERN.
10. REPEAT ALL THE STEPS UNTIL THE
REGISTRATION MARKS ON THE COPY
ALIGN WITHIN ONE HALF OF THE UNlT
LINES OF THE TEST PATTERN (FIGURE 1)
.
11. IFTHE CUSTOMER INDICATESTHAT
VELLUM (USO) TRACING PAPER (RX) OR
FlLM WILL BE USED, PERFORM THE
FOLLOWING STEPS:
A. VELLUM (USO) TRACING PAPER
(EO)
-
USE THE ARROW BUTTONS
TO ENTER THE CODE [22] AND
PERFORM THIS PROCEDURE USING
VELLUM (USO) TRACING PAPER
(RX) FOR THE COPY.
B. FILM
-
USE THE ARROW BUTTONS
TO ENTER THE CODE [23] AND
PERFORM THIS PROCEDURE USING
FlLM FOR THE COPY.
12/98
ADJ 5.1
4-60 3001