Xerox 3001 Service Manual page 296

Special Tests
(Continued)
Description
Relative Humidity. This test
is used to display the relative
humidity. A low number
indicates a low relative
humidity.
Reset the NVM. This test is
used to reset the NVM values
to their default values. A
tone will sound for two
seconds while this test is
being run.
This test is used to check the
operation of the following
input switches: Front
Document Sensor, Rear
Document, Media Prefeed
Sensor, Cut Sheet Feeder
Select, and Motion Sensor.
Refer to the Input Diagnostic
Test Procedure.
Description
VA or Foreign Accessory
nabled and a 450 ms output
ulse after the motion sensor
etects the trail edge of the
VA or Foreign Accessory not
nabled.
VA
or Foreign Accessory
nabled and a 450 ms output
ulse each time the copy
This is
sed to allow the accessory to
length of media
sed.
edia image limit.
only in conjunction with
ode 39 enabled.
epending on the setting in
ode 31, the value set in code
0 indicates the number of
eet or metres of image that
ill be copied. If value is set to
is no limit. Value set
ill also be sent to the foreign
ccessory.
-
Value
-
Code
-
- -
Description
Keyboard Beep Enabled.
Customer option that has the
beeper sound whenever a
button is pushed. Not to be
used as a test for the buttons.
Cut Sheet Feeder Motor. This
test will allow the cut sheet
feeder to partially feed a
sheet of media and then to
stop. The feed assembly will
retract from the stack of
media. Enter the test and
then press the feeder select
button.
Feed clutch on time. With
this code enabled, the feed
clutch will be deenergized
after 46 inches of media has
been fed.
0 Disabled
1
Enabled
-
Value
12/98
Diagnostics
6-6 3001