Error Led And Buzzers; Error Led; Description Of Led And Error Status - SNBC BTP-R180II User Manual

Printer will stay in pause state after cutting paper (ERROR LED flashes).Then keep pressing FEED
button, the printer will enter button config mode.
d- Power switch (8)
"O" power is to turn off printer. "—" power is to turn on printer.
e- Top cover uplifting alarm sensor (11)
Monitor top cover status: open/close.
f- Paper end sensor (12)
To detect if paper is existing or not when using continuous paper; To detect the paper mark when using
black mark paper.
g- Paper guide (13)
There are 4 long slots in paper house bottom. Paper house width can be adjusted to below different
value by inserting paper guide into different slots:82.5 ± 0.5mm ,, 80± 0.5 mm,76± 0.5 mm,69.5± 0.5 mm,
57± 0.5 mm. the paper house width is 82.5 ± 0.5mm if take out the paper guide
Caution:
 The paper guide is an indispensable part of the printer and should be kept with the printer.

3.2 Error LED and Buzzers

3.2.1 Error LED

Power Indicator (Green) (POWER)
Error Indicator (Red) (ERROR)

3.2.2 Description of LED and Error Status

Error information
Print head is overheating
Input voltage is abnormal
Cutter Error
Cover Is Open
Paper End
Paper near end
Calibration error or can not find the
marks
Caution:
 The temperature of the print-head is detected by means of a thermistor sensor. If the temperature of
the print head becomes higher than 65℃, the protection circuit of the printer will force the printer to
stop printing.
LED Status
On
Off
Off
Flash Printer is in error status or Paper near end
ERROR LED
Six times
Five times
Four times
Three times
Twice
One times
One times
- 7 -
BTP-R180II User's Manual
Description
Printer is powered on
Printer is powered off
Printer is in normal status
Buzzer
Six times
Five times
Four times
Three times
Twice
-
-