Connecting A D-Phy Source Device With The Solder-Down Probes; Connecting A Mipi D-Phy Source Device Under Test Using The Envision X14 Solder-Down Probes - Teledyne Envision X14 Quick Start Manual

Envision X14 CSI/DSI Analyzer/Generator - Quick Start Guide
qd@<10.212.178.19> password: qd
#mipi-scope> mipitx lb (lb as loopback)
5. Take a capture of the incoming looped back signal using the
procedures described below for Capturing a MIPI D-Phy CSI-2/DSI-
2 stream.
6 Connecting a D-Phy Source Device with the
Solder-Down Probes
This chapter describes how to connect a MIPI D-Phy source device to
the Envision X14 for analysis using the solder-down probes. The source
device under test could either be a camera module for CSI-2 or an
Application Processor (SoC) for DSI-2.
6.1 Connecting a MIPI D-Phy Source Device Under
Test using the Envision X14 Solder-Down Probes
This procedure describes how to connect the Envision X14 solder-down
probes to the MIPI D-Phy source device. This procedure assumes that
the device under test is on a MIPI D-Phy development board. The D-
Phy differential pairs will have to be identified on the board.
To connect your source DUT to the Envision X14:
1. Connect the SMP cables provided with the Envision X14 and the
Probe Assembly to the rear of the Envision X14 Probe Assembly
using the illustration below.
Page 22 February 22, 2024