Chapter 4 Adjustments And Updating Of Settings, Required After Parts Replacement; If You Replace The Main Pcb - Brother HLL3290CDW Service Manual

CHAPTER 4 ADJUSTMENTS AND
1.

IF YOU REPLACE THE MAIN PCB

■
What to do after replacement
• Configure for Country/Region and Model (Function code 74)
• Installing the Firmware (Sub Firmware and Main Firmware)
• Initializing the EEPROM of the Main PCB (Function code 01)
• Adjusting Touch Panel (Function code 61)
• Continuous Adjustments of Density and Registration Sensor (Function code 73)
• Acquisition of White Level Data (Function code 55)
• Setting the Serial Number (Function code 80)
■
What you need to prepare
(1) USB flash memory
(2) One USB cable
(Only when installing the firmware and setting the Serial Number using computer.)
(3) Create a temporary folder on the C drive of the computer (Windows
(4) Service setting tool (SvSettingTool)
(Only when setting the Serial Number using computer.)
Copy it into the temporary folder that has been created in the C drive.
(5) Download utility (Filedg32.exe)
(Only when installing the firmware using computer.)
Copy it into the temporary folder that has been created in the C drive.
(6) Maintenance printer driver (Maintenance_driver.zip)
(Only when installing the firmware and setting the Serial Number using computer.)
When the maintenance printer driver is not installed, copy this file into the temporary
folder created on the C drive, and extract the copied file. Refer to
INSTALLING THE MAINTENANCE PRINTER DRIVER"
(7) Firmware
Sub firmware
Main firmware
(8) Touch pen
UPDATING OF SETTINGS,
REQUIRED AFTER PARTS
REPLACEMENT
djf or upd file (ex. ******_A.djf or ******_A.upd)
djf or upd file (ex. ******_A.djf or ******_A.upd)
4-1
®
XP or later).
"APPENDIX 3
to install the driver.
Confidential