If You Replace The Main Pcb Assy - Brother DCP-8110DN Service Manual

1. IF YOU REPLACE THE MAIN PCB ASSY

<What to do after replacement>
• Installing firmware (panel firmware, sub firmware, and main firmware)
• Setting by country (function code: 74)
• Initializing the EEPROM of the main PCB ASSY (function code: 01)
• Setting serial number and entering adjusted value of laser unit
• Acquiring white level data (function code: 55)
• Adjusting touch panel (function code: 61)
What you need to prepare
(1) One USB cable
(2) Create a temporary folder on the C drive of the computer (Windows
(3) Service setting tool (BrUsbn.zip)
Copy this file into the temporary folder created on the C drive. Extract the copied file and
double-click "BrUsbsn.exe" to start it.
(4) Download utility (FILEDG32.EXE)
Copy this file into the temporary folder created on the C drive.
(5) Maintenance driver (MaintenanceDriver.zip)
When the maintenance driver is not installed, copy this file into the temporary folder
created on the C drive, and extract the copied file. Refer to
MAINTENANCE DRIVER"
(6) Firmware
Panel firmware
(Touch panel models only)
Sub firmware
Main firmware
LZXXXX: First six digits of the part number of the firmware
$: Alphabetic character representing the revision version of the firmware
(7) USB flash memory
for the installation procedure.
(E.g.) LZXXXX_$.upd (firmware installation using PC)
(E.g.) LZXXXX_$.djf (firmware installation using USB flash memory)
(E.g.) LZXXXX_$.upd (firmware installation using PC)
(E.g.) LZXXXX_$.djf (firmware installation using USB flash memory)
(E.g.) LZXXXX_$.upd (firmware installation using PC)
(E.g.) LZXXXX_$.djf (firmware installation using USB flash memory)
4-1
®
XP or higher).
"APPENDIX 3 INSTALLING
Confidential