Points To Note In Replacing The Fixing External Heat Belt Or External Heating Assembly - Canon imagePRESS C10000VPSeries Troubleshooting Manual

Points to note in replacing the fixing external heat belt or external
heating assembly
[Symptom/Question]
After replacing the fixing external heat belt (FE3-1881) or external heating assembly (FM1-A377) in the primary/secondary fixing
assembly, E007-0102/0202 may occur.
-E007-0102: Primary Fixing External Heat Belt full displacement error
-E007-0202: Secondary Fixing External Heat Belt full displacement error
[Cause]
Some fixing external heat belts have inner peripheries with rough surface and this condition makes the shifting speed of the belt
unstable, and would eventually end in the above-mentioned symptom.
[Remedy/Answer]
Replace the fixing external heat belt or external heating assembly only after upgrading to System Software Ver29.03 and Dcon
Ver23.02 or later (Service Information (Software) Ref No: F20278), and then execute the following service mode:
The above works are unnecessary when replacing the primary fixing assembly or secondary fixing assembly.
- Primary fixing : COPIER>FUNCTION>FIXING>F1EX-INT
- Secondary fixing : COPIER>FUNCTION>FIXING>F2EX-INT
229