Canon imagePRESS C10000VPSeries Troubleshooting Manual page 122

C) Checking the halogen heater of the pressure roller
C-1) Check that the heater mounting plate on the front side and the insulator of the halogen heater end are correctly attached.
C-2) Check that the heater mounting spring on the rear side and the insulator of the halogen heater end are correctly attached.
D) Checking the halogen heater cable of the fixing pressure belt assembly
D-1) Check if the halogen heater cable is appropriately wired.
The photo [A] shows a state where the halogen heater cable [1] on the rear side is adequately arranged along the guide.
The photo [B] shows a state where the halogen heater cable [1] on the rear side is pinched [a] between the guide and the
separation drive mount. In this case, fix the wiring correctly.
The photo [C] shows a state where the halogen heater cable on the front side is properly arranged along the guide. The white
dashed line indicates the correct route that the halogen heater cable inside of a guide plate is wired.
117