Canon imagePRESS C10000VPSeries Troubleshooting Manual page 110

b-7) Remove the 2 bearings [1], the 2 E-rings [2], the gear [3] and the dowel pin [4] from the transmission shaft removed in the
step b-6).
b-8) Apply about the size of a rice grain (20mg) of super lube grease to each area of where the bearings are engaged (2 colored
areas indicated with arrows) of the new type transmission shaft (FE8-3617-010). Then, reassemble the parts removed in the step
b-7).
[Note] When applying super lube grease to the transmission shaft, be sure not to apply it to any areas of the shaft other than
where the bearings are engaged.
b-9) Attach the parts in the reverse order from the step b-6) to step b-1).
[Note] When attaching the parts, apply about the size of a rice grain (20mg) of super lube grease to the area where the transmission
shaft and bearing are engaged [a] right before attaching the bearing and the E-ring removed in the step b-2). Be careful of the
timing of applying the super lube grease.
105