Canon imagePRESS C10000VPSeries Troubleshooting Manual page 54

[Reference] If the cable on the rear side is removed in this state, the 2nd transfer cleaner assembly can be removed from the
pre-registration/feed unit. However, all the steps from the following steps or later can be performed while the 2nd transfer cleaner
assembly is remained on the pre-registration/feed unit.
9) Remove the 2nd transfer drive motor assembly [1] together with the sheet metal while paying attention not to damage the
sensor flag attaching shaft [2] with the sheet metal.
10) Remove the 4 screws [1], and remove the transfer cleaner drive unit in a way it is pulled forward.
In case chips of the shaft are scattered in the lower part of the 2nd transfer cleaner assembly, wipe out the chips with a cloth.
11) Apply the same amount of super lube grease as 3 grains of rice (60mg) respectively to the entire surface of the gear on the
rear side and roller of the new transfer cleaner drive unit (FM1-H026-000).
[Reference]
- Clean the gear and apply the grease to it after every 1000K sheet.
- If the shaft is replaced by itself, replace the shaft of the transfer cleaner drive unit here. Apply the same amount of super lube
grease as 1 grain of rice (20mg) respectively to the shaft and the abrasion of the bearing indicated with arrows below. Note that
the grease is applied to the entire surface of the shaft thinly and uniformly and that the grease shall not be applied to the rubber
belt.
49