Download  Print this page

Error In Reading Image Position Adjustment Caused By Paper Fault - Canon imagePRESS C10000VPSeries Troubleshooting Manual

Hide thumbs

Advertisement

Error in reading image position adjustment caused by paper fault

[Symptom]
When executing the image position adjustment by using the scanner, "Correctly place the test page on the platen glass" may be
displayed at the time of reading the test page.
[Reference] Image position adjustment mode
User Mode > Preferences > Paper Settings > Paper Type Management Settings > Image Position Adjustment > Select Method
"Use Scanner"
[Cause]
If the paper edge used for the test page is not at a right angle due to trimming failure or being folded or if transfer failure occurs
on the test page image, it is regarded as faulty image at the time of reading the test page and the above-mentioned symptom
occurs.
[Service work]
1) Check the condition and image of the test page paper used for adjustment.
2) If the test page paper is not at a right angle,
2-1) if the paper [a] edge is folded [b], correct the fold and perform reading again.
2-2) if the paper [a] edge is lost due to trimming failure or damage [b] or if the test page image gets dirty [c], cancel the image
position adjustment, output test page using the new paper without trimming failure, and execute the image position adjustment
again.
3) If there is transfer failure [b] on the test page [a] image, cancel the image position adjustment, execute auto adjust gradation
and adjust the secondary transfer voltage, and then output the test page using the new paper to execute the image position
adjustment again.
User Mode "Settings/Registration > Adjustment/Maintenance > Adjust Image Quality > Auto Adjust Gradation > Full Adjust"
User Mode "Settings/Registration > Preferences > Paper Settings > Paper Type Management Settings > Adjust Secondary
Transfer Voltage"
22

Advertisement

Table of Contents

   Related Manuals for Canon imagePRESS C10000VPSeries

   Related Content for Canon imagePRESS C10000VPSeries

Comments to this Manuals

Symbols: 0
Latest comments: