Canon imagePRESS C10000VPSeries Troubleshooting Manual page 254

3) Be sure to have the insulator [a] of the pressure roller heater on the rear side [A] pass below the cable guide [1] of the secondary
fixing assembly of the machine. After confirming that the insulator [a] of the pressure roller heater is not positioned over the cable
guide [1], set the bearing [2] in the bearing holder [3].
[Note] If the bearing is set in place with the insulator [a] of the pressure roller heater positioned over the cable guide [1], the heater
may break from the weight of the pressure roller being applied to it.
[Reference] The left photo is the image of the insulator of the pressure roller heater on the rear side positioned over the cable
guide. The pressure roller is being removed for easier viewing. The right photo shows the correct state.
4) While keeping the insulator of the front end of the pressure roller heater inside the pressure roller [B], set the bearing [3] in the
bearing holder [4] without going over the heater retainer (Front) [2] of the secondary fixing assembly of the machine.
249