E5A3-808X/E5B5-8016 And 1Fa9 Jam Code Due To Sliding Failure Of Dust Buffer (Perfect Binder-A1/B1/C1/D1/E1) - Canon imagePRESS C10000VPSeries Troubleshooting Manual

E5A3-808x/E5B5-8016 and 1FA9 jam code due to sliding failure of
dust buffer (Perfect Binder-A1/B1/C1/D1/E1)
[Symptom/Question]
In the machine earlier than the following countermeasure cut-inserial numbers in factory, when copying using perfect binder,
E5A3-8081/E5A3-8082/E5B5-8016 or 1FA9 jam may occur.
- E5A3-8081: Error in the stack buffer tray motor (M39) of Perfect Binder (Stack buffer tray home position sensor (S78) is not
turned OFF.
- E5A3-8082: Error in the stack buffer tray motor (M39) of Perfect Binder (Stack buffer tray home position sensor (S78) is not
turned ON.)
- E5B5-8016: Error in waste paper detection of Perfect Binder
- 1FA9: Stationary jam of rotation home position sensor 1 (S95)
[Cause]
As the life of the dust buffer [2] in dust collecting area [1] advances, the surface [a] that comes in contact with the arm [3] gets
shaved. This causes sliding failure of the dust buffer, resulting in the above symptom.
[Remedy/Answer]
When the above symptom occurs, prepare some lint-free paper and alcohol, and clean the dust buffer in the following procedure.
[Note] When bringing down the trimming assembly, be sure to do so with two people.
1) Refer to Service Manual and remove the rear cover.
2) Refer to Service Manual and remove the stack rotation assembly.
3) Remove all the connectors [1].
4) Remove the 2 screws [2], and then remove the cable arm [1] from the trimming assembly.
232