2) Remove the 3 claws and then remove the harness guide cover [1].
3) Remove the 11 saddles securing the harness and the 1 reusable band. Then, remove the 3 connectors (2 white connectors
and 1 black connector).
4) Remove the 3 screws securing the edge registration detect assembly. Two screws are located in front [A] and one screw is
located in rear [B]. The photo [A] is the top view and the photo [B] is the front view.
5) While pressing the rear right side of the edge registration detect assembly, lift the front side of the assembly and remove it
from the machine by pulling it out.
218