Canon imagePRESS C10000VPSeries Troubleshooting Manual page 115

b) The claw of secondary transfer outer belt tension roller holder breakage
When pressing the claw of the tension roller during some work and if the claw is pressed with finger on its edge, a force larger
than expected is applied to the curved area of the claw, resulting in the above symptom.
The figure [A] shows a correct state where the finger is put against the whole face of the claw.
The figure [B] shows an incorrect state where the finger is put against only a part of the edge of the claw.
[Service work]
Based on the issue mentioned below, follow the steps and replace the parts.
a) Secondary transfer outer belt breakage (2ND TRANSFER BELT ASSEMBLY)
Prepare the new type 2nd transfer belt assembly (FM1-A345-020). Refer to Service Manual and replace the assembly.
b) Secondary transfer outer belt breakage (BELT CLEANER ASSEMBLY)
Prepare new type side seal (front/rear) and the belt cleaner lower cover set as a new service part. Refer to Service Manual and
replace them.
• FL0-5503-010 SEAL, SIDE, FRONT [1] 1pc.
• FL0-5504-010 SEAL, SIDE, REAR [1] 1pc.
• FL0-5505-000 COVER, BELT CLEANER, LOWER [3] 1pc.
Photo [A] shows the old type side seal and [B] shows the new type one.
110