Canon imagePRESS C10000VPSeries Troubleshooting Manual page 99

A-8) Pressing push switch SW385 determines shifting amount of the front alignment plate.
A-9) After the alignment plate position is adjusted to the position that is thought to be proper, be sure to check the result in the
way shown in the attached video.
When the alignment plate is adjusted in proper position, the paper placed in the process tray would enter the process tray smoothly
after being pulled towards the front once with a finger and let go.
When the alignment plate is adjusted in a position where the paper warps, the paper placed in the process tray would get stuck
and not enter the process tray smoothly after being pulled towards the front once with a finger and let go.
A-10) After the alignment plate adjustment is complete, return all the bit switches in SW382 to OFF.
A-11) To check the state, print multiple stapled sets.
A-12) Check staple quality of the printed document. The specification of staple misalignment for finisher is within 2mm depending
on installation environment of the machine and papers used. After having the alignment plate width adjusted, staple misalignment
should improve to be within 2mm. If staple misalignment on all sets of the printed document is within 2mm, the work completes
here.
If staple misalignment is more than 2mm, proceed to the step B). Adjusting Paddle Height.
B). Adjusting Paddle Height
B-1) Set DIP SW382 on the switch PCB as shown in the figure below.
[Note] SW1, SW4 and SW5 are ON.
B-2) Press SW385 so that the height adjustment for the paddle is ready now.
94