Canon imagePRESS C10000VPSeries Troubleshooting Manual page 197

20) Check if the patch sensor shutter opens and closes smoothly and also the shutter is opened fully when it is opened.
21) Reassemble the parts in reverse order from Step 16).
22) Implement Service Mode > COPIER > Function > MISC-P >AT-IMG-X since the operations of releasing and applying pressure
to the intermediate transfer unit had been executed.
b). Error of the shutter slide lever
When the symptom occurs, replace the patch sensing sensor unit with the new type by referring to Service Manual.
• patch sensing sensor unit (Y/M) : FM1-H019-030
• patch sensing sensor unit (C/K) : FM1-H020-030
d). Dirt of the detection surface of the patch sensor shutter solenoid sensor
Perform works by following the procedures below.
1) Perform the steps up to 12) of a). Incorrect position of the shutter solenoid of Service Work to pull out the process unit.
2) Put the edge of the blower brush to the corner of the dot [a] on the rear side of the process unit to clean the patch sensor
shutter solenoid sensor [1].
[Reference] Clean it after every 2000K printing.
[Service parts]
No. Part Number
1 Old FM1-H019-020
New FM1-H019-030
2 Old FM1-H020-020
New FM1-H020-030
Description
SENSOR UNIT, PATCH SENSING,Y/M
SENSOR UNIT, PATCH SENSING,Y/M
SENSOR UNIT, PATCH SENSING,C/K
SENSOR UNIT, PATCH SENSING,C/K
192
Q'ty Fig.No.
1 -> 0 600A
0 -> 1
1 -> 0 600B
0 -> 1