Feature Vrrp - Cisco Nexus 3548 Command Reference Manual

feature vrrp

feature vrrp
To enable the Virtual Router Redundancy Protocol (VRRP), use the feature vrrp command. To disable
VRRP, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Default Disabled
Command Modes Global configuration mode
Command History Release
5.0(3)A1(1)
Usage Guidelines You must enable the VRRP feature before you can configure VRRP.
This command does not require a license but if you want to enable Layer 3 interfaces, you must install
the LAN Base Services license.
Examples This example shows how to enable the VRRP feature:
switch# configure terminal
switch(config)# feature vrrp
switch(config)#
This example shows how to disable the VRRP feature:
switch# configure terminal
switch(config)# no feature vrrp
switch(config)#
Related Commands Command
clear vrrp
show feature
show vrrp
vrrp
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
130
feature vrrp
no feature vrrp
Modified
This command was introduced.
Description
Clears all the software counters for the specified virtual router.
Displays the status of features on a switch.
Displays VRRP configuration information.
Configures a VRRP group on an interface.
Chapter Unicast Routing Commands
OL-27852-01