Default-Information Originate (Eigrp) - Cisco Nexus 3548 Command Reference Manual

default-information originate (EIGRP)

default-information originate (EIGRP)
To generate a default route into the Enhanced Interior Gateway Routing Protocol (EIGRP), use the
default-information originate command. To disable this feature, use the no form of this command.
Syntax Description
always
route-map map-name
Command Default Disabled
Command Modes Address-family configuration mode
Router configuration mode
Router VRF configuration mode
Command History Release
5.0(3)A1(1)
Usage Guidelines
This command requires the LAN Base Services license.
Examples
This example shows how to originate a default route (0.0.0.0/0) to all routes that pass the Condition route
map:
switch# configure terminal
switch(config)# router eigrp 201
switch(config-router)# address-family ipv4 unicast
switch(config-router-af)# default-information originate route-map Condition
switch(config-router-af)#
Related Commands Command
address-family
copy running-config
startup-config
default-metric
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
102
default-information originate [always] [route-map map-name]
no default-information originate
(Optional) Generates the default route if the route is not in the EIGRP
routing information base.
(Optional) Generates the default route only if the route is permitted by the
route map. The map name is an alphanumeric string of up to 63 characters.
Modification
This command was introduced.
Description
Enters address-family configuration mode.
Saves the configuration changes to the startup configuration file.
Sets the metric for routes redistributed into EIGRP.
Chapter Unicast Routing Commands
OL-27852-01