Delay Minimum - Cisco Nexus 3548 Command Reference Manual

Chapter Unicast Routing Commands

delay minimum

To delay the Hot Standby Router Protocol (HSRP) initialization after a reload or after an interface comes
up, use the delay minimum command. To disable this function, use the no form of this command.
Syntax Description
min-delay
reload reload-delay
Command Default
The HSRP delay default is 0 seconds.
Command Modes
Interface configuration mode
Command History Release
5.0(3)A1(1)
Usage Guidelines
The delayed HSRP initialization configuration allows the interface and router to stabilize after the
interface comes up and helps to prevent HSRP state flapping.
This command does not require a license.
Examples
This example shows how to configure a minimum delay of 3 seconds and a group initialization delay of
10 seconds:
switch# configure terminal
switch(config)# configure terminal
switch(config)# interface ethernet 1/5
switch(config-if)# no switchport
switch(config-if)# ip address 192.168.9.5 255.255.255.0
switch(config-if)# hsrp 1
switch(config-if)# delay minimum 3 reload 10
switch(config-if)# ip 192.168.0.100
switch(config-if)#
Related Commands Command
feature hsrp
OL-27852-01
delay minimum [min-delay] reload [reload-delay]
no delay minimum [min-delay] reload [reload-delay]
Minimum time (in seconds) to delay HSRP group initialization after an
interface comes up. This period applies to all subsequent interface events.
The default is 0 seconds.
Specifies the time period to delay HSRP group initialization after the router
has reloaded. This period applies only to the first interface-up event after the
router has reloaded. The default is 0 seconds.
Modification
This command was introduced.
Description
Enables the HSRP configuration.
Cisco Nexus 3548 Switch NX-OS Unicast Routing Command Reference
delay minimum
113